Computer-Aided Modeling and Analysis of Power Processing Systems (CAMAPPS), phase 1

The large-signal behaviors of a regulator depend largely on the type of power circuit topology and control. Thus, for maximum flexibility, it is best to develop models for each functional block a independent modules. A regulator can then be configured by collecting appropriate pre-defined modules for each functional block. In order to complete the component model generation for a comprehensive spacecraft power system, the following modules were developed: solar array switching unit and control; shunt regulators; and battery discharger. The capability of each module is demonstrated using a simplified Direct Energy Transfer (DET) system. Large-signal behaviors of solar array power systems were analyzed. Stability of the solar array system operating points with a nonlinear load is analyzed. The state-plane analysis illustrates trajectories of the system operating point under various conditions. Stability and transient responses of the system operating near the solar array's maximum power point are also analyzed. The solar array system mode of operation is described using the DET spacecraft power system. The DET system is simulated for various operating conditions. Transfer of the software program CAMAPPS (Computer Aided Modeling and Analysis of Power Processing Systems) to NASA/GSFC (Goddard Space Flight Center) was accomplished

The effects of surface finish and grain size on the strength of sintered silicon carbide

The effects of surface treatment and microstructure, especially abnormal grain growth, on the strength of sintered SiC were studied. The surfaces of sintered SiC were treated with 400, 800 and 1200 grit diamond wheels. Grain growth was induced by increasing the sintering times at 2050 C. The beta to alpha transformation occurred during the sintering of beta-phase starting materials and was often accompanied by abnormal grain growth. The overall strength distributions were established using Weibull statistics. The strength of the sintered SiC is limited by extrinsic surface flaws in normal-sintered specimens. The finer the surface finish and grain size, the higher the strength. But the strength of abnormal sintering specimens is limited by the abnormally grown large tabular grains. The Weibull modulus increases with decreasing grain size and decreasing grit size for grinding

Metallic characteristics in superlattices composed of insulators, NdMnO3/SrMnO3/LaMnO3

We report on the electronic properties of superlattices composed of three different antiferromagnetic insulators, NdMnO3/SrMnO3/LaMnO3 grown on SrTiO3 substrates. Photoemission spectra obtained by tuning the x-ray energy at the Mn 2p -> 3d edge show a Fermi cut-off, indicating metallic behavior mainly originating from Mn e_g electrons. Furthermore, the density of states near the Fermi energy and the magnetization obey a similar temperature dependence, suggesting a correlation between the spin and charge degrees of freedom at the interfaces of these oxides

Direct relation between the low-energy spin excitations and superconductivity of overdoped high-TcT_c superconductors

The dynamic spin susceptibility, $\chi''(\omega)$, has been measured over the energy range of $2 \leq \omega \leq 10$ meV for overdoped La$_{2-x}$Sr$_{x}$CuO$_{4}$. Incommensurate (IC) spin excitations are observed at 8 K for all superconducting samples for $0.25 \leq x \leq 0.28$ with $\chi''$ peaking at $\sim 6$ meV. The IC peaks at 6 meV become smaller in intensity with increasing $x$ and, finally, become unobservable for a sample with $x=0.30$ which has no bulk superconductivity. The maximum $\chi''$ decreases linearly with $T_c$(onset) in the overdoped region, implying a direct cooperative relation between the spin fluctuations and the superconductivity.Comment: 4 pages, 4 figure